Panasonic PT-RZ570B

Chapter 3 Basic Operations — Projecting
ENGLISH - 47
Projecting
Check the external device connection (x page 34) and the power cord connection (x page 40), and turn on
the power (x page 41) to start projection. Select the image to project, and adjust appearance of the projected
image.
Selecting the input signal
Remote control Control panel
The input of the image to project can be switched. Method to switch the input is as follows.
f Press the input selection button on the remote control and directly specify the input to project.
f Press the <INPUT SELECT> button on the control panel to display the input selection screen, and select the
input to project from the list.
Switching the input directly with the remote control
The input for projection can be switched by directly specifying it with the input selection button on the remote
control.
1) Press the input selection button (<HDMI 1>, <HDMI 2>, <DIGITAL LINK>, <COMPUTER 1/2>, <VIDEO>,
<DVI-D>).
<HDMI 1>
Switches the input to HDMI1.
The image of the signal input to the <HDMI 1 IN> terminal is projected.
<HDMI 2>
Switches the input to HDMI2.
The image of the signal input to the <HDMI 2 IN> terminal is projected.
<DIGITAL LINK>
Switches the input to DIGITAL LINK.
The image of the signal input to the <DIGITAL LINK/LAN> terminal is projected.
<COMPUTER 1/2>
Switches the input to COMPUTER1 or COMPUTER2.
Switches to the other input when one input has already been selected. The image of the signal input
to the <COMPUTER 1 IN> terminal or the <COMPUTER 2 IN/1 OUT> terminal is projected.
<VIDEO>
Switches the input to VIDEO.
The image of the signal input to the <VIDEO IN> terminal is projected.
<DVI-D>
Switches the input to DVI-D.
The image of the signal input to the <DVI-D IN> terminal is projected.
Attention
f Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back.
Set the [PICTURE] menu → [SYSTEM SELECTOR].
f Conrm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →
[ASPECT].
Note
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK/
LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the <DIGITAL LINK> button is pressed. The input
can also be changed using the RS-232C control command.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
f Set the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] → [INPUT SETTING] in accordance with the signal input to the <COMPUTER 1
IN> terminal.
f Set the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] → [COMPUTER2 SELECT] to [COMPUTER2 IN] when a signal is to be input to
the <COMPUTER 2 IN/1 OUT> terminal.