Panasonic PT-TW351R

ENGLISH - 67
[Power management]
This function optimizes lamp power according to the operating status to reduce power consumption.
[Power management]
Set the operation as following if there is no signal input.
1) Press as to select [Power management].
2) Press the <ENTER> button.
f The [Power management] screen is displayed.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Ready]
The countdown timer is displayed after 30 seconds without input signal. The projection lamp turns off
and cools down when reaching the set time, meanwhile the projector will enter into the ready mode of
the power management. The projection lamp will be turned on if the input signal is reconnected or any
button (except for power button <v/b>) is pressed.
[Shut down]
The countdown timer is displayed after 30 seconds without input signal. The projection lamp is turned
off and cooled down when reached the set time, then the projector enter into standby status.
[Off]
Power management function is off.
[Timer]
Set the time that the Power management starts to work.
[Ready
Countdown]
The time from the state which the management function is working to the standby mode can be set to
0 ~ 30 minutes when [Power management] is set to [Ready]. The increment is 1 minute.
Setting [Timer] in step 3)
The time that the Power management starts to work can be set to 1-30 minutes. The increment is one minute.
1) Press as to select [Timer].
2) Press the <ENTER> button.
3) Press as to switch the setting time.
f The setting times will switch each time you press the button.
Setting [Ready Countdown] in step 3)
The time from the state which the management function is working to the standby mode can be set to 0 ~ 30 minutes when
[Power management] is set to [Ready]. The increment is one minute.
1) Press as to select [Ready Countdown].
2) Press the <ENTER> button.
3) Press as to switch the setting time.
f The items will switch each time you press the button.
[0 Min]
The ready mode of the power management function is continued.
[1 Min] ~ [30 Min]
From the ready mode of the power management function to the standby mode when the projector
reach the set time.
[Filter counter]
You can check and reset the lter usage time. And, you can set the cleaning cycle for the air lter.
1) Press as to select [Filter counter].
2) Press the <ENTER> button.
f The [Filter counter] screen is displayed.
3) Press as to switch the item.
f The items will switch each time you press the button.
Chapter 4 Settings - [Expand] menu