ENGLISH - 83
About VueMagic Pro
(The wireless module (Model No.: ET-WML100) of the optional accessories is required if the wireless LAN is connected.)
By using still image transfer application software “VueMagic Pro”, you can transfer images to the projector when iPad /
iPhone / iPod touch or Android terminals are connected to this projector through the wireless LAN.
Connecting with the VueMagic Pro compatible device
1) Check the SSID set in the projector.
f Check the [SSID] in the [Expand] menu → [Network] → [Network information].
2) Choose the SSID of this projector on the wireless LAN setting screen of the connected device, and
then connect the wireless.
3) Press the <MEMORY VIEWER/USB DISPLAY/NETWORK> button on the remote control to select
[Network].
f Switch to the network input.
f Press the <INPUT/ENTER> button on the control panel and select the input source in the Input menu.
f Check the login password (a four-digit number that is automatically generated) and the IP address (wireless LAN) which
are displayed on the Network idle screen.
4) Start the VueMagic Pro mobile presenter application of the correspondent VueMagic Pro devices.
5) Choose the model No. of this projector in the projector list.
f The connection conrmation screen is displayed.
6) Choose the display position.
f The password entry screen is displayed.
7) Enter the login password and click [OK].
f The connected device screen is projected on the screen.
Note
f When connecting to the iOS device or Android device, you must install the dedicated application “VueMagic Pro” to the
device. For detailed information, refer to the following web site. (Only in English.)
URL http://vuemagic.pixelworks.com
Disconnecting
with the VueMagic Pro compatible device
Close the VueMagic Pro mobile presenter application of the device by clicking the .
Chapter 5 Operation of Function - About VueMagic Pro
To Next Page
Loading...
