f The user name and password of a standard user account without administrator rights can be set on the [Set up password] page
(x page 134) of the web control screen.
[NETWORK SECURITY]
Make settings to protect the projector from external attacks via LAN and unauthorized use.
Setting the password of the administrator account (x page 103) is required for setting the [NETWORK
SECURITY] menu.
[COMMAND PROTECT]
Make settings for the connection authentication when using the command control function.
1) Press as to select [NETWORK SECURITY].
2) Press the <ENTER> button.
f The [NETWORK SECURITY] screen is displayed.
3) Press qw to switch the [COMMAND PROTECT] setting.
[ENABLE]
Connect to the projector in protected mode.
The user name and password of the administrator account are required for the connection
authentication.
[DISABLE]
Connect to the projector in non-protected mode.
Connection authentication is not performed.
f The conrmation screen is displayed once the setting is switched.
4) Press qw to select [OK], and press the <ENTER> button.
f The [COMMAND PROTECT] screen is displayed.
5) Press as to select [PASSWORD], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
6) Press asqw to select a character, and press the <ENTER> button.
f Enter the password of the administrator account.
7) After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [COMMAND PROTECT] screen is displayed.
8) Press asqw to select [OK], and press the <ENTER> button.
Note
f When [COMMAND PROTECT] is set to [DISABLE], connection authentication is not performed, making it vulnerable to threats on the
network. Be aware of the risks before making settings.
f For details on how to use the command control function, refer to “Control commands via LAN”. (x page 152)
[NETWORK CONTROL]
Set the network control of this projector.
Setting the password of the administrator account (x page 103) is required for using the network function of the
projector.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3) Press as to select an item and press qw to change the setting.
[WEB CONTROL]
Set to [ON] to control with the web browser.
[COMMAND CONTROL]
Set to [ON] to control with the <SERIAL IN> terminal control command format (x page 155). Refer
to “Control commands via LAN” (x page 152).
[COMMAND PORT]
Set the port number used for command control.
[Crestron Connected(TM)]
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
106 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
