Panasonic PT-VMW51

Projecting
Check the connections of the external devices (x page 37) and connection of the power cord (x page 42)
and then power on the projector (x page 44) to start projecting. Select the image and adjust the state of the
image.
Selecting the image input for projection
Switch the image input for projection. Method to switch the input is as follows.
f Press the input selection buttons on the remote control and directly specify the input to project.
f Press the <INPUT SELECT> button on the control panel to display the input guide and select the input to be
projected.
Remote Control Control Panel
Switching the input directly with the remote control
The input for projection can be switched by directly specifying it with the input selection button on the remote
control.
1) Press the input selection buttons (<HDMI 1>, <HDMI 2>, <DIGITAL LINK>, <COMPUTER 1/2>,
<NETWORK/USB>).
Remote control buttons Input
Usage
<HDMI 1> HDMI 1
Switches the input to HDMI 1.
Displays the image signals input via the <HDMI IN 1> terminal.
<HDMI 2> HDMI 2
Switches the input to HDMI 2.
Displays the image signals input via the <HDMI IN 2> terminal.
<DIGITAL LINK>
*1
DIGITAL LINK
Switches the input to DIGITAL LINK.
Displays the image signals input via the <DIGITAL LINK/LAN>
terminal.
<COMPUTER 1/2>
COMPUTER 1
Switches the input to COMPUTER 1 or COMPUTER 2.
Displays the image signals input via the <COMPUTER 1 IN> terminal
or the <COMPUTER 2 IN> terminal.
If one input has been selected already, the input will be switched
every time the button is pressed.
COMPUTER 2
<NETWORK/USB>
MEMORY VIEWER
Switches the input to MEMORY VIEWER or NETWORK.
If one input has been selected already, the input will be switched
every time the button is pressed.
f MEMORY VIEWER: Displays the still images in the USB memory
with the Memory Viewer function. (x page 112)
f NETWORK: Displays images transmitted from a terminal over
wireless LAN / wired LAN by using the image transfer application
software. (x page 114)
NETWORK
*1 Not available for the remote control supplied with PT-VMZ51S and PT-VMZ41.
f When switching inputs, the input guide for detailed or simple display is temporarily displayed. For the input
guide, refer to “Switching the input with the control panel” (x page 51) or the [DISPLAY OPTION] menu
→ [ON-SCREEN DISPLAY] → [INPUT GUIDE].
Attention
f Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back. Set the
following menu items according to the input signal.
g [PICTURE] menu → [RGB/YC
B
C
R
]
g [PICTURE] menu → [RGB/YP
B
P
R
]
g [PICTURE] menu → [RGB-SYSTEM]
50 - ENGLISH
Chapter 3 Basic Operations - Projecting