EasyManua.ls Logo

Panasonic PT-VMW51

Panasonic PT-VMW51
167 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note
f The magnication is not displayed in the moving screen.
f The digital zoom function is canceled if the input signal changes during a digital zoom.
f During a digital zoom, the freeze function is disabled.
f The digital zoom function may not work properly for some computer signals.
Switching the image aspect ratio
Switch the image aspect ratio according to the input.
button
1) Press the <ASPECT> button.
f The setting will change each time you press the button.
Note
f Refer to the [POSITION] menu [ASPECT] (x page 76) for details.
Using the presentation timer function
The presentation timer can be operated.
The presentation can be performed while conrming the elapsed time or remaining time against the specied
time.
button
1) Press the <P-TIMER> button.
f The count is started.
2) Press the <P-TIMER> button again.
f The count is stopped.
Note
f The elapsed time or the remaining time is displayed at the lower right of the projected image when using the presentation timer function.
f The count will be resumed from interruption when the <P-TIMER> button is pressed.
f The presentation timer function will be terminated by pressing the <P-TIMER> button for over three seconds.
f For details about the setting of the presentation timer function, refer to the [DISPLAY OPTION] menu → [P-TIMER]. (x page 82)
Using the FUNCTION button
Some frequently used menu items can be assigned to the <FUNCTION> button on the remote control so that it
can be used as an shortcut button.
button
1) Press the <FUNCTION> button.
Assigning functions to the <FUNCTION> button
1) Press the <MENU> button to display the menu items (main menu, sub menu, or details menu) to be
assigned.
f Refer to “Navigating through the menu” (x page 62) for the operation of the menu.
2) Press and hold the <FUNCTION> button for three seconds or more.
Note
f After the setting, the assigned menu items will be displayed as [ASSIGNED FUNCTION] in the operation guide under the menu.
f To cancel the function assignment, use the [PROJECTOR SETUP] menu → [FUNCTION BUTTON]. (x page 91)
58 - ENGLISH
Chapter 3 Basic Operations - Operating with the remote control

Table of Contents

Related product manuals