Panasonic PT-VMW51

[SELF TEST] display
[SELF TEST] can be checked in the WEB control screen [Status] → [Projector status].
The following list shows the alphanumeric symbol that is displayed when an error or a warning has occurred and
its details. Conrm “Action number”, and follow the measure in “Measure for error and warning” (x page 148).
Error/warning display Details Action number
U11 Intake air temp. warning 1
U13 Exhaust air temp. warning 1
U21 Intake air temp. error 1
U23 Exhaust air temp. error 1
FL5 Light Bank 1 warning 2
FL6 Light Bank 2 warning 2
FL7 Light Bank 3 warning
*1
2
FL8 Light Bank 4 warning
*1
2
FH0 PW error(SUB) 2
H11 Intake air temp. sensor error 2
H13 Exhaust air temp. sensor error 2
U04 Air lter clogged 4
FL1 Light unit error 3
FE1 Lcd R fan error 2
FE2 Lcd G fan error 2
FE3 Pbs fan error 2
FE4 Pw fan error
*2
2
FE5 Light fan error 2
FE6 Power fan error 2
FE7 Motor fan error 2
U25 Light temperature 1 error 1
U27 Light temperature 2 error
*3
1
F16 Angle sensor error 2
H14 Light temperature sensor 1 error 2
H16 Light temperature sensor 2 error
*3
2
U16 Light temperature 1 warning 1
U18 Light temperature 2 warning
*3
1
F18 Air pressure sensor error 2
F61 Light driver communication error 2
U78 Air lter clogged 4
*1 Only for PT-VMZ71, PT-VMZ61 and PT-VMW61.
*2 Only for PT-VMZ71.
*3 Only for PT-VMZ51, PT-VMZ51S, PT-VMZ41 and PT-VMW51.
Note
f The self-diagnosis display and the details of the malfunction may be different.
f For errors and warnings that are not described in the table, consult your dealer.
r Measure for error and warning
Action
number
Measure
1 The operating environment temperature is too high. Use the projector in an appropriate operating environment temperature
*1
.
2
If the error/warning display does not go off even after unplugging the power plug from the outlet and turning on the power
again, consult your dealer.
3
The light source has failed to turn on. If the light source does not light up after turning the power off and on, consult your
dealer.
4
Perform maintenance or replacement of the lter. (x page 142)
*1 For the operating environment temperature of the projector, refer to “Operating temperature” (x page 160).
148 - ENGLISH
Chapter 6 Maintenance - [SELF TEST] display