Panasonic PT-VMW51 - Page 129

Note
f Changing LAN settings while connected to the LAN may cause the connection to cut out.
f The setting values of the [Network cong] page will return to the factory default when the [INITIALIZE] of the [NETWORK] menu is executed
(x page 110) .
[Ping test] page
Check whether the network is connected to the E-mail server, POP server, DNS server, etc.
Click [Detailed set up] → [Ping test].
1
2
3
4
1 [Input IP address]
Enter the IP address of the server to be tested.
2 [Submit]
Execute the connection test.
3 Example of display when the connection has succeeded
4 Example of display when the connection has failed
[ECO management set up] page
Settings related to the ECO management function of the projector can be made.
Click [Detailed set up] → [ECO management set up].
1
9
2
3
4
5
6
7
8
1 [LIGHT POWER]
Displays the [LIGHT POWER] setting.
2 [AUTO POWER SAVE]
Sets to [ON] when setting [AMBIENT LIGHT DETECTION] and
[SIGNAL DETECTION].
3 [AMBIENT LIGHT DETECTION]
Selects to enable ([ON])/disable ([OFF]) the environmental
luminance interlock function.
4 [SIGNAL DETECTION]
Selects to enable ([ON])/disable ([OFF]) the no signal interlock
function.
5 [POWER MANAGEMENT]
Selects the power consumption mode.
6 [TIMER]
Selects the time that the light source is turned off when the
POWER MANAGEMENT function is using.
7 [QUICK STARTUP]
Displays the [QUICK STARTUP] setting.
8 [VALID PERIOD]
Select the valid period until the [QUICK STARTUP] function is
disabled after going into the standby mode.
9 [Submit]
Updates the settings.
Note
f For details of each setting item, refer to the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] (x page 87) on the projector.
ENGLISH - 129
Chapter 5 Operation of Function - Web control function