Powering ON/OFF
ENGLISH -
27
Basic Operation
Complete peripheral connections (with a 1 )
computer, VCR, etc.) before turning on the
projector.
Connect the projector’s AC power cord into an 2 )
AC outlet. The <ON(G)/STANDBY(R)> indicator
lights red. Open the lens cap.
Press the <3 ) > button to on the control
panel or on the remote control. The <ON(G)/
STANDBY(R)> indicator lights green and the
cooling fans start to operate. The preparation
display appears on the screen and the count
down starts.
After the countdown, the input source that was 4 )
selected the last time and the lamp power status
icon appear on the screen.
If there is no signal input when start on the 5 )
projector, or the current signal is missed while
operating the projector, the Video/Computer
selection window will be displayed on the screen,
please move the pointer to input source desired
by pressing the ▲▼ and the <ENTER> button.
And then follow the input signal guidance window
to correct the signal and connection.
If the projector is locked with a PIN code, PIN
code input dialog box will appear. Enter the PIN
code as instructed on the next page.
Note
When the Logo select function is set to Off, the logo will
z
not be shown on the screen (
Æ
page 52).
When [Countdown off] or [Off] is selected in the Display
z
function, the preparation display will not be shown on the
screen (
Æ
page 52).
When the Input search function is set to [On 2], the input
z
signal will be searched automatically (
Æ
page 51).
When the Direct on function is set to [On], the projector
z
will be turned on automatically by connecting the AC
power cord to an AC outlet.
Turning On the Projector
(2)
(3)
(3)
Video/Computer selection
06
Selected input source and Lamp mode
Input source
The preparation display will disappear
after 30 seconds.
Preparation display
Lamp power status
To Next Page
Loading...
