Technical Information
88
- ENGLISH
Appendix
Serial terminal
The serial connector which is on the connector panel of the projector conforms to the RS-232C interface
specication, so that the projector can be controlled by a personal computer which is connected to this connector.
Connection
J
Pin assignments and signal names
J
D-Sub 9-pin (female)
Outside view
Pin No. Signal name Contents
— NC
TXD Transmitted data
RXD Received data
— NC
GND Earth
— NC
CTS
Connected internally
RTS
— NC
Communication conditions
J
Signal level RS-232C-compliant Character length 8 bits
Sync. method Asynchronous Stop bit 1 bit
Baud rate 9 600 bps X parameter None
Parity None S parameter None
Note
The serial control cannot be used when [RS232C] is set to [DIGITAL LINK].
z
The Baud rate of PT-VW430 / PT-VX500 / PT-VW435N / PT-VX505N series and PT-VW431D series is different.
z
D-Sub 9-pin (male)
D-Sub 9-pin (female)
Connecting terminals
on projector
Communication cable
Computer
To Next Page
Loading...
