Memory Viewer function
The Memory Viewer function makes it is possible to project the video or still image stored in the USB memory.
What you can project with the Memory Viewer function
Memory Viewer function supports the following les.
Video
Extension Video codec Audio codec Video format Audio format
mov
H.264/AVC
MotionJpeg
AAC
Linear PCM
Maximum:
1 920 x 1 080/30 fps
Maximum:
48 kHz 2 ch
(It is up to 16 kHz
stereo when the codec
is linear PCM)
avi
H.264/AVC
MotionJpeg
Mpeg4
mp3
AAC
Linear PCM
mp4
H.264/AVC
Mpeg4
AAC
Mpeg4 AAC-LC
mpg/mpeg Mpeg2 Mpeg1 Layer2
wmv WMV9 WMA
Still image
Extension Format
jpg/jpeg
Maximum resolution: 8 000 x 8 000
bmp
Maximum resolution: 2 000 x 2 000
support: 1, 4, 8, 16, 24, 32 bit
Note
f The maximum size of le is 2 GB.
The maximum number of folder/le is up to 1 000. If it exceeds the folder/le cannot display and an error message appears.
f It maybe impossible to play even if the le is recorded in the supported format.
Cautions on using USB Memory
Please observe the following.
f Do not put USB memory or its cap within close reach of children. Swallowing them may cause suffocation.
f If the smoke or questionable odor rise, remove the USB memory from the projector, and then contact your dealer.
f Do not put water, chemical or oil to the USB memory. It may cause short out or re.
f Do not put foreign objects or put metal objects to the USB terminal. Static electricity may cause data loss or data corruption.
f Do not remove the USB memory from the computer or the projector while the USB memory is reading out or writing the data.
It may cause data loss or data corruption.
f Do not store the USB memory where high temperature, humid or dusty place or magnetized items are around.
Note
f It is compatible with the USB memory sold in the market.
f It cannot be used the other format other than the formatted with FAT16 and FAT32.
Inserting the USB memory
1) Insert the USB memory directly into the <USB A (VIEWER)> terminal.
Attention
f When inserting the USB memory, conrm the direction of the plug and do not damage the terminal.
Removing the USB memory
1) Make sure that the USB memory is not flashing, and then unplug it.
Attention
f Please note following points when removing the USB memory.
- The indicator of the USB memory is blinking means that the projector is reading out the data. Do not remove the USB
memory while it is blinking.
- When using a USB memory without an indicator, you cannot recognize when the projector reading out the data. Please
remove it from the projector after closing the memory viewer function or turning off the projector.
- Do not insert and remove the USB memory in a short time. Remove the USB memory at least 5 seconds after inserting.
And insert it at least 5 seconds after removing. When inserting or removing the USB memory, the projector takes about 5
seconds to identify the operation.
ENGLISH
-
119
Chapter 5 Operation of Function - Memory Viewer function
To Next Page
Loading...
