[FUNCTION BUTTON]
The function assigned to the <FUNCTION> button of the remote control is displayed. You can also release the assigned
setting.
Releasing assigned function to the <FUNCTION> button
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press the <ENTER> button.
4) When the confirmation message is displayed, select [OK] and press the <ENTER> button.
Note
f You can also cancel the assigned settings by displaying the on-screen menu, selecting the menu item to be canceled (main
menu, submenu, or details menu), and then pressing the <FUNCTION> button for at least 3 seconds.
[AUDIO SETTING]
You can perform more detailed setting for Audio.
Adjusting the volume
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [VOLUME].
4) Press qw to adjust the level.
Operation Adjustment Range
Press the w button.
Increases the volume.
0 ~ +63
Press the q button.
Decreases the volume.
Setting the mute
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.
[OFF]
Audio is output.
[ON]
Audio is not output.
Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch [IN STANDBY MODE].
f The items will switch each time you press the button.
[OFF]
Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode when [STANDBY MODE] is set to [NORMAL].
At this time, press the <VOL - / VOL +> buttons on the remote control or qw buttons on the
control panel to adjust the volume.
82 -
ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
