f The initial setting is [KEY], there is a risk that the leakage of information by a third party. Change the initial setting is
necessary.
f As the DHCP server is already functioning, select [ON] before connecting a computer.
Detailed setup of [USER1] / [USER2] / [USER3]
1) Press the <ENTER> button when [NORMAL] is selected.
f The [NORMAL] screen is displayed.
2) Press qw to select [USER1], [USER2] or [USER3], and press the <ENTER> button.
f The [WIRELESS DETAILED SETUP 1/2] screen is displayed.
3) Press as to select an item, and press qw to change the setting according to the instructions.
[NAME CHANGE]
The identied names of the projectors on the application software can be changed.
[DHCP]
ON: If a DHCP server exists in the network to which the projector is connected, the
IP address will automatically be acquired.
OFF: If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP ADDRESS], [SUBNET MASK ] and [DEFAULT
GATEWAY].
[IP ADDRESS]
Enter the IP address if DHCP server is not used.
[SUBNET MASK]
Enter the subnet mask if DHCP server is not used.
[DEFAULT GATEWAY]
Enter the gateway address if DHCP server is not used.
[DNS1]
Enter the DNS server address if DHCP server is not used.
[DNS2]
Enter the alternate DNS server address if DHCP server is not used.
Note
f Before using the DHCP server, make sure the DHCP server is already functioning.
f For details of IP ADDRESS, SUBNET MASK, DEFAULT GATEWAY and DNS server address, ask the network administrator.
f A wired LAN and wireless LAN cannot be used in the same segment.
4) Press s.
f The [WIRELESS DETAILED SETUP 2/2] screen is displayed.
5) Press as to select the item and press asqw to change the setting according to the instructions.
[SSID]
Enter the same character string that is registered in the access point.
[AUTHENTICATION]
Set the user authentication method used by the network to be connected.
[OPEN]
Select when the access point authentication method is Open System.
[SHARED]
Select when the access point authentication method is Shared Key.
[WPA-PSK ]
Select when the access point authentication method is WPA-PSK.
[WPA2-PSK ]
Select when the access point authentication method is WPA2-PSK.
[WPA-EAP/WPA2-EAP ]
Select when the access point authentication method is WPA-EAP/WPA2-EAP.
[WPA-EAP]
Select when the access point authentication method is WPA-EAP.
[WPA2-EAP]
Select when the access point authentication method is WPA2-EAP.
[ENCRYPTION]
Select the encryption method to be used for communication between the projector and
the network.
[NONE]
Select when transmit without encryption.
It is selectable only when [AUTHENTICATION] is [OPEN] or [SHARED].
[WEP]
Select when Encryption is WEP.
[TKIP]
Select when Encryption is TKIP.
Selectable when [AUTHENTICATION] is either [WPA-PSK], [WPA2-PSK], [WPA-EAP],
[WPA2-EAP].
[AES]
Select when Encryption is AES.
Selectable when [AUTHENTICATION] is either [WPA-PSK], [WPA2-PSK], [WPA-EAP],
[WPA2-EAP].
[DEFAULT KEY]
Set 1 – 4 numerals for the default key.
It is can be set when [AUTHENTICATION] is [OPEN] or [SHARED] and [DEFAULT KEY]
is [WEP].
92 -
ENGLISH
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
