rConnecting terminals
1 2 3 4 5 6
7 8 9 10 11
1 <LAN> terminal
This is the LAN terminal to connect to the network.
2 <USB A (VIEWER/WIRELESS)> terminal
When using the Memory Viewer function, attach the USB
memory directly to this terminal. (x page 90)
Please attach the wireless module (Model No.: ET-WML100)
directly to this terminal when using the wireless LAN function.
(x page 95)
3 <USB B (DISPLAY)> terminal
This terminal is used to connect the projector to the computer
with a USB cable when you want to use the USB display
function.
4 <COMPUTER 1 IN> terminal
This is the terminal to input RGB signals, YC
B
C
R
/YP
B
P
R
signals,
or Y/C signals.
5 <COMPUTER 2 IN/1 OUT> terminal
This is the terminal to input RGB signals or YC
B
C
R
/YP
B
P
R
signals. It can also output the signals input from <COMPUTER 1
IN> terminal to an external device.
6 <HDMI 1 IN> terminal / <HDMI 2 IN> terminal
These are the terminals to input HDMI signal.
7 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control the
projector by connecting a computer.
8 <VIDEO IN> terminal
This is the terminal to input video signals.
9
<AUDIO IN 3 (L/R)> terminal
This is the terminal to input audio signals.
Left input (L) and right input (R) are provided for the <AUDIO IN
3> terminal.
10
<AUDIO IN 1> terminal / <AUDIO IN 2> terminal
These are the terminals to input audio signals.
11 <VARIABLE AUDIO OUT> terminal
This is the terminal to output the input audio signal to the
projector.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
26 - ENGLISH
Chapter 1 Preparation - About your projector
To Next Page
Loading...
