Panasonic PT-VX430

[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (x page 52) for the operation of the menu screen.
[STATUS]
You can check the using status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
[SIGNAL]
[NAME] Displays the name of input signal.
[FREQUENCY] Displays the scanning frequency of input signal.
[RUNTIME]
[PROJECTOR] Displays the actual usage time of projector.
[LAMP
(ET-LAV300)]
Displays the model No. of the replacement lamp unit for this projector.
[ECO]
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [ECO].
[NORMAL]
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [NORMAL].
[TOTAL]
*1
Displays the total runtime converted from the runtime at [ECO]
and [NORMAL]. Please use it to predict when to replace the lamp
unit.
[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.
*1 The total runtime displayed is calculated automatically using the following conversion formula.
Formula for lamp unit replacement time (rough estimate)
A × 1 + B × 5/7
f A : The luminous lamp runtime when [LAMP POWER] is set to [NORMAL]
f B : The luminous lamp runtime when [LAMP POWER] is set to [ECO]
Note
f If you attach a lamp unit used in a projector of a model different from the projector (PT-VW360, PT-VX430) to the projector, or when the
lamp unit used in the projector to a projector of a different model, the [RUNTIME] displayed in [STATUS] may differ from the actual time.
f For the network status, refer to the [NETWORK/USB] menu → [STATUS]. (x page 88)
f The model number of the optional replacement lamp unit is subject to change without prior notice.
[COMPUTER1 INPUT SETTING]
Switch the input setting of the <COMPUTER 1 IN> terminal.
1) Press as to select [COMPUTER1 INPUT SETTING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[RGB/YP
B
P
R
] Select when inputting the RGB signals or YP
B
P
R
(YC
B
C
R
) signals to the <COMPUTER 1 IN> terminal.
[Y/C]
Select when inputting the Y/C signals to the <COMPUTER 1 IN> terminal by using the D-SUB - S Video
conversion cable (model number: ET-ADSV).
[COMPUTER2 SELECT]
Switch the input/output of the <COMPUTER 2 IN/1 OUT> terminal.
1) Press as to select [COMPUTER2 SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[COMPUTER2 IN] Select when inputting the RGB signals or YP
B
P
R
(YC
B
C
R
) signals to the <COMPUTER 2 IN/1 OUT> terminal.
[COMPUTER1 OUT]
Select when the RGB signals or YP
B
P
R
(YC
B
C
R
) signals input to the <COMPUTER 1 IN> terminal is output
from the <COMPUTER 2 IN / 1 OUT> terminal.
Note
f When COMPUTER2 input is selected, [COMPUTER2 SELECT] cannot be set.
74 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu