1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
[FILTER COUNTER] Displays the usage time of the lter.
[TIMER] Sets the replacement cycle of the air lter.
[FILTER COUNTER
RESET]
Resets the air lter usage time.
Setting [TIMER]
If you want to regularly replace the air lter, set its cycle time. When the air lter usage time reaches the set time,
a message of “FILTER COUNTER has reached the set time” prompting you to replace the air lter is displayed on
the projection screen.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[1000 H] ~ [7000 H]
Select to display the message. You can set the replacement cycle of the air lter in increments of 1000
hours..
[OFF]
Select not to display the message.
Setting [FILTER COUNTER RESET]
Resets the usage time of the air lter.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [FILTER COUNTER RESET].
4) Press the <ENTER> button.
5) When the confirmation screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
f The display of [FILTER COUNTER] changes to “0H”.
[INITIALIZE ALL]
Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE ALL].
2) Press the <ENTER> button.
f The [INITIALIZE ALL] screen is displayed.
3) When the confirmation is displayed, press qw to select [OK] and then press the <ENTER> button.
f The [NOW INITIALIZING...] screen is displayed and then the [POWER OFF.] screen will be displayed.
4) Press the <ENTER> button.
f The operation of other buttons is disabled.
f The initial setting (display language) screen will be displayed when turning on the projector next time.
Note
f The projector will enter into the standby status to reect the setting values when [INITIALIZE ALL] is executed.
f When [INITIALIZE ALL] is executed, [STANDBY MODE], [EMULATE], [FILTER COUNTER] and the setting values of [NETWORK/USB]
cannot be returned to the factory default values. For details about the initialization of [NETWORK/USB], please refer to [NETWORK/USB] →
[INITIALIZE] (x page 88).
ENGLISH - 81
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
