Note
f [TIMER] is enabled when [MODE] is set to [COUNT DOWN].
Using the presentation timer
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
3) Press as to select the item, and press the <ENTER> button.
[START]
The count is started.
[STOP]
The count is stopped.
[RESTART]
The count is resumed.
[RESET]
The count is reset.
f When [START] or [RESTART] is selected, the elapsed time or the remaining time is displayed at the bottom right of the
projected image.
f When [STOP] is selected, the elapsed time or the remaining time when the count was stopped is displayed at the
bottom right of the projected image.
f When [RESET] is selected, proceed to Step 4).
4) Press the <MENU> button three times, then menu screen will disappear.
f The start time is displayed at the bottom right of the projected image.
Note
f Presentation timer operations are also possible by the <P-TIMER> button on the remote control. (x page 43)
f The security message set in the [SECURITY] menu → [TEXT DISPLAY] (Æ page 78) is not displayed when the elapsed
time or remaining time is displayed.
f The elapsed time or remaining time is not displayed when the menu screen is displayed.
f The start time becomes "000:00" when [MODE] is set to [COUNT UP].
f When [MODE] is set to [COUNT DOWN], the start time becomes the value set at [TIMER].
f The time gauge turns clockwise when [COUNT UP] is set, and turns counterclockwise when [COUNT DOWN] is set.
Ending the presentation timer
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
3) Press as to select [EXIT].
4) Press the <ENTER> button.
[OTHER FUNCTIONS]
You can perform some of the remote control button operations instead of menu operations.
1) Press as to select [OTHER FUNCTIONS].
2) Press the <ENTER> button.
f The [OTHER FUNCTIONS] screen is displayed.
3) Press as to select the item.
[AUTO SETUP]
For details, refer to "Using the AUTO SETUP function". (x page 40)
[FREEZE]
The projected image is paused temporarily and the sound stopped regardless of the playback of
the external equipment. To release this function, press the <RETURN> button or the <FREEZE>
button on the remote control.
[AV MUTE]
Turn off audio and image when the projector is not used for a certain period of time. To release
this function, press the <RETURN> button or the <AV MUTE> button on the remote control.
[DIGITAL ZOOM]
For details, refer to "Using the DIGITAL ZOOM function". (x page 42)
4) Press the <ENTER> button.
Chapter 4 Settings - [DISPLAY OPTION] menu
ENGLISH
-
69
To Next Page
Loading...
