15
Before Using
Using the Remote Control
(PV-GS35 Only)
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical
and horizontal directions from the central axis
1 Direct the Remote Control at the Remote
Control Sensor
15
of the Camcorder and
press an appropriate button.
[VCR1]:
Press the [Ι►] Button and [ ■ ] Button
simultaneously.
1
[VCR2]:
Press the [◄Ι] Button and [ ■ ] Button
simultaneously.
2
• When the battery in the Remote Control is replaced,
the mode is automatically reset to [VCR1] Mode.
• The above operating ranges are for indoor use.
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously, they
can be operated individually by selecting different
Remote Control Modes.
• If the Remote Control Mode of the Camcorder
and that of the Remote Control do not match with
each other, [REMOTE] will appear. When the
Remote Control is operated for the first time after
the Camcorder is turned on, [CHECK REMOTE
MODE] (p. 64) will appear and operation is
impossible. Set the same Remote Control Mode.
Setup on the Camcorder
Set [ REMOTE] on the [ SETUP] Sub-Menu to
the desired Remote Control Mode. (pp. 23, 24)
Setup on the Remote Control
15°
15°
15°
15°
12
15
Power Supply
Using the AC Adaptor
1 Connect the DC Cable to the Camcorder.
2 Connect the DC Cable to the AC Adaptor.
3 Connect the AC Cable to the AC Adaptor
and the AC Jack.
• Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch
28
on
the Camcorder to [OFF] and make sure that
[POWER] Lamp
32
is not lit. (p. 19)
Using the Battery
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder
when batteries from other companies are used.
1 Attach the Battery to the AC Adaptor and
charge it.
2 Put the Battery on the Battery Mount by
aligning the mark, and then securely plug it
in.
Before use, fully charge the Battery.
• Since the Battery will not be charged when
the DC Cable is connected to the AC Adaptor,
disconnect it from the AC Adaptor.
• The [CHARGE] Lamp lights up, and charging
starts.
• When the [CHARGE] Lamp goes off, charging is
completed.
• When the battery is completely discharged, the
[CHARGE] Lamp blinks at first, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer
than usual.
To Next Page
Loading...
