10 Operation Checks and Main Component
Replacement Procedures
TOP PREVIOUS NEXT
“ATTENTION SERVICER”
Some chassis components maybe have sharp edges. Be careful when diassembling and servicing.
1. This section describes the procedures for checking the operation of the major printed circuit
boards and replacing the main components.
2. For assembly after operation checks or replacement, reverse trhe respective procedures.
Special reassembly procedures are described only when required.
3. Select items from the following index when checks or replacement are requirement.
4. Refer the part no. on the page of “Main Component Replacement Procedures”, if necessary.
Content
● Checking Procedure for each major P.C.B.
1. Cross-Ref] 24956: Body: Checking for the Panel P.C.B.Checking for the Panel P.C.
B .............................................................................................................................. P.g. 11 ~
12
2. Checking of the Main & CD Servo P.C.
B ............................................................................................................. P.g. 12 ~ 13
● Disassembly and Assembly of Traverse
Deck ..................................................................................................... P.g.13 ~ 14
● Main Component Replacement
Procedures ......................................................................................................... P.g.15 ~ 16
Warning:
To Next Page
Loading...
