Panasonic S-36MK2E5A

9
ENGLISH
(2) For the Right and Right Bottom Piping
Step 1 Pull out the Indoor piping
↓
Step 2 Install the Indoor Unit
↓
Step 3 Insert the power supply cord and connection
cable
↓
• Insertthecablesfrombottomoftheunit
through the control board hole until terminal
board area.
Step 4 Secure the Indoor Unit
Fig. 3-13
(3) For the Embedded Piping
Step 1 Replace the drain hose
↓
Step 2 Bend the embedded piping
↓
• Useaspringbenderorequivalenttobend
the piping so that the piping is not crushed.
Step 3 Pull the connection cable into Indoor Unit
↓
• Thepowersupplycordandindoorunit
and outdoor unit connection cable can be
connected without removing the front grille.
Step 4 Cut and flare the embedded piping
↓
• Whendeterminingthedimensionsofthe
piping, slide the unit all the way to the left on
the installation plate.
Step 5 Install the Indoor Unit
↓
Step 6 Connect the piping
↓
Step 7 Insulate and finish the piping
↓
Step 8 Secure the Indoor Unit
Install the indoor unit
Hook the indoor unit onto the upper portion of installation plate.
(Engage the indoor unit with the upper edge of the installation
plate). Ensure the hooks are properly seated on the installation
plate by moving it in left and right.
Fig. 3-14
Secure the Indoor Unit
Press the lower left and right side of the unit against the
installation plate until hooks engages with their slot (sound
click).
Fig. 3-15
Insert the connection cable
70 – 80 mm
Fig. 3-16
Fig. 3-17
To take out the unit, push the
PUSH
marking at the
bottom unit, and pull it slightly towards you to disengage
the hooks from the unit.
(This can be used for left rear piping and bottom piping also.)
Right and Right Bottom piping
Tape it with piping
in a position as
mentioned in
Fig. below.
Drainhose
Cover for
the right
piping
Cover for
the left
piping
Cover for the
bottom piping
Piping
Hooks at installation plate
Sleeve for piping hole
Piping
Drainhose
Indoor unit
Installation plate
Unit’s hook
Connection cable
Gas side piping
Liquid side piping
Drainhose
Guide
surface
Connection
cable
About
PUSH
marking
Pana_F616380_All_L.indb 9 2013-12-11 17:38:07