Step 10 Remove 4 screws.
Step 11 Remove Deck P.C.B.
* The mechanism as shown below is for DECK1. For the
one of DECK 2, perform the same procedures.
Step 1 Release the 2 claws, and then remove the head
connector.
Step 2 Remove 6 screws.
Step 3 Remove the sub chassis.
·
Disassembly of pinch roller ass’y & head block
Step 12 Release the 2 claws, and then remove the pinch roller
(R), (F).
Step 13 Release ther 2 claws, and then remove the head
connector.
Step 14 Remove 2 screws.
Step 4 Remove 2 screws.
16.12.1. Replacement for the CD motor ass ’ y, capstan belt A, capstan belt B and
winding belt
60
SA-VK81DEE
To Next Page
Loading...
