Stop the test signal.
Repeat. Repeat.
DISTANCE FILTER
Step 3
Two seconds each.
C, RS, LS, SW
Select the speaker
channel.
Enter the distance of the front,
center and surround speakers
from the seating position
Change the distance so that the sound
from all the speakers (except for the
subwoofer) reaches you at the same time.
You can select distances between 3 and
30 feet at one-foot intervals.
The factory settings are:
FRONT and CENTER: 10 FEET
SURROUND: 5 FEET
Change the cut-off for bass
output from the front speakers
If you set the front speakers to “SMALL”,
the filter is set to 100 Hz. Raise the cut-off
if the bass from the front speakers is
unsatisfactory so bass is output through
the subwoofer.
You can raise the cut-off from 100 Hz to
either 150 Hz or 200 Hz.
Adjust the level of the other speakers based on the
output of the front speakers. (Speakers set as “NONE” or
“NO” are skipped. Adjust the volume of the front speakers
with [VOLUME].)
C (center), RS (right surround), and LS (left surround)
can be adjusted between –10 dB and +10 dB, with 0
being the level of the front speakers.
Adjust center and surround output to the same apparent
level of the front speakers.
For SW (subwoofer), you can select “– – –” so there is no
output, “MIN” for minimum output, a level between 1 and
19, or “MAX” for maximum output.
Adjust subwoofer output so it is balanced with the front
speakers. Subwoofer output is easily influenced by the
source. You can also change its level while playing
something for better effect (
\
page 14).
To Next Page
Loading...
