Sound modes
The unit sets the sound mode to suit the signal.
Adding surround effects to stereo sources
Dolby Pro Logic 2 processor works not only on sources recorded
with Dolby Surround, but also on any stereo source.
The following modes are available when using Dolby Pro
Logic
2.
Enjoy an enhanced sound experience with greater presence
and spread by using these SFC modes with PCM or
analog stereo sources.
Choose from the following modes.
■ Using Dolby Pro Logic
22
■ Using the Sound Field Control (SFC)
Dolby Pro Logic 2 and SFC modes remain in effect until
you change them.
¡¡
To return to stereo sound
Press [STEREO/2CH MIX].
Listening to multi-channel sources in stereo
When surround sources are played in this mode, the
sounds intended for the other speaker channels are
played through the front speakers.
The 2CH MIX mode remains in effect until you change input mode
or turn off the unit.
¡¡
To return to surround sound
Press [STEREO/2CH MIX].
Notes on sound modes
When input is Dolby Digital or DTS:
¡¡
You cannot use SFC.
When input is PCM with sampling frequencies of 96, or 88.2 kHz:
¡¡
You cannot add surround effects with Dolby Pro Logic 2or SFC.
When you have selected “NONE” for both the center and
surround speakers:
¡¡
You cannot use Dolby Pro Logic 2 or SFC.
When you finish listening
Be sure to reduce the volume and press [POWER 8] to switch the unit
to standby.
Notes on digital input
This unit can decode the following signals:
¡¡
Dolby Digital
¡¡
DTS
¡¡
PCM, including PCM with sampling frequencies of 96 or
88.2 kHz
It cannot decode:
¡ Other digital signals, such as MPEG
¡ Dolby Digital RF signals from a laser disc player
To Next Page
Loading...
