14
RQT6964
Control guide
Others
[SUBWOOFER]
For selecting subwoofer level.
Adjust the level in 5 steps:
SW MIN, SW 5, SW 10, SW 15, and
SW MAX.
Select SW “– – –” to stop output.
[TONE]
To adjust the bass and treble.
[BALANCE]
To adjust the front speaker balance.
[LEVEL]
Use when adjusting speaker level.
[EFFECT]
Use when adjusting Dolby Pro Logic
2 or SFC effects.
[–/L, +/R]
First select SLEEP, EFFECT, LEVEL,
TONE or BALANCE, then press [–/L]
or [+/R] to adjust.
[^, RECEIVER]
Standby/on button.
[DVD, TV, FM, AM, VCR]
Input mode and remote control mode
buttons.
[+, –, VOLUME]
To adjust the volume.
[MUTING]
To mute the volume.
[1, 2, 3, 4, 5, 6, 7, 8, 9, 0]
To enter radio frequencies and
channels.
[
>
=
10, ENTER]
To enter two digit channels.
[STEREO/2CH MIX]
For selecting STEREO or 2CH MIX
mode.
[DOLBY PRO LOGIC
22
]
For selecting a Dolby Pro Logic 2
mode:
MOVIE, MUSIC or PANORAMA.
[SFC]
For selecting SFC modes.
[TEST]
To start the speaker test signal.
[DIMMER]
For dimming the unit’s display and
turning off the panel light.
[INPUT MODE]
For selecting AUTO, ANALOG or
DIGITAL.
[DISC, DIRECT TUNING]
To enable selection of radio stations
by frequency.
[1, CH, 2]
For selecting preset radio channels.
Buttons not explained on this page are used only to operate other equipment. Refer to the separate Remote
Control Operation Guide for details.
For your reference
¡When using the subwoofer
Sound can be distorted if you raise the volume while subwoofer
level is high. Reduce subwoofer level if this occurs.
¡When muting is on
Muting is also canceled when the unit is turned off.
Remote control
[AUX]
To select auxiliary (AUX) input.
[SLEEP]
To start the sleep timer.
To Next Page
Loading...
