12
RQT6964
Control guide
Others
Main unit
Display
[POWER 8]
Press to switch the unit from on to standby mode or vice
versa.
In standby mode, the unit is still consuming a small amount of
power.
Standby indicator [^]
When the unit is connected to the AC mains supply, this
indicator lights up in standby mode and goes out when the
unit is turned on.
Remote control signal sensor
[% DIGITAL, % PL
22
, DTS]
Light to indicate the source’s input signal and decoding format
used.
% DIGITAL: Dolby Digital sources
% PL
22
:
Dolby Pro Logic 2 decoder is being used
DTS: DTS sources
[kHz, MHz]
Frequency unit indicators
kHz: AM, or PCM sampling frequency
MHz: FM
[˜, TUNED, ST, MONO]
Radio indicators
˜:
Flashes or lights during presetting.
TUNED: A station is tuned.
ST: A stereo FM broadcast is tuned.
MONO: You have switched to
monaural mode with [FM
MODE] to improve reception.
General display
Shows the input mode, radio
frequency, and other general
information.
To Next Page
Loading...
