50
VQT2Z56
Specifications
Specifications are subject to change without notice.
GENERAL
Power consumption
Main unit: 60 W
Active subwoofer: 25 W
Digital transmitter: 1.2 W
Power consumption in standby mode
Main unit: Approx. 0.1 W
Power consumption in off mode
Active subwoofer: Approx. 0.4 W
Power supply:
(For both Main unit and
Active subwoofer)
AC 220 V to 240 V, 50 Hz
iPod/iPhone Connector: DC OUT 5 V 500 mA MAX
WIRELESS LAN Connector:
(USB 2.0 standard)
DC OUT 5 V 500 mA MAX
Dimensions (WkHkD)
Main unit: 1035 mmk188 mmk85 mm
(When Wall Setting)
1035 mmk195 mmk91 mm
(When Table Setting)
Active subwoofer: 250 mmk323 mmk356 mm
Digital transmitter: 43.5 mmk37.3 mmk8.2 mm
Mass:
Main unit: Approx. 5.5 kg
(Dimensions and Weight do not
include SUB Woofer)
Active subwoofer: Approx. 6.7 kg
Digital transmitter: Approx. 0.0095 kg
(For both Main unit and Active subwoofer)
Operating temperature
range: 0 oC to 40 oC
Operating humidity range: 35 % to 80 % RH
(no condensation)
AMPLIFIER SECTION
RMS TTL POWER OUTPUT: 300 W
1 kHz, 10 % total harmonic distortion
FRONT: 90 W per ch (4 ≠)
ACTIVE SUBWOOFER (SB-WA500)
RMS POWER OUTPUT:
100 Hz, 10 % total harmonic distortion
120 W per ch (8 ≠)
SPEAKER SECTION
FRONT SPEAKERS (BUILT-IN)
Type: 2 WAY 2 SPEAKER Bass-ref.
Woofer: 6.5 cm CONE TYPE
Tweeter: 2.5 cm SEMI-DOME TYPE
Frequency range: 95 Hz to 30 kHz (j16 dB),
105 Hz to 25 kHz (j10 dB)
ACTIVE SUBWOOFER (SB-WA500)
Type: 1 WAY 1 SPEAKER Kelton
type
Woofer: 16 cm CONE TYPE
Passive radiator: 25 cm
Frequency range: 35 Hz to 180 Hz (j16 dB),
40 Hz to 160 Hz (j10 dB)
FM TUNER SECTION
Frequency range: 87.50 MHz to 108.00 MHz (50 kHz step)
Antenna terminals: 75 ≠ (unbalanced)
TERMINAL SECTION
USB:
(Top) USB 2.0 High Speed
USB port power: DC OUT 5 V 500 mA MAX
Bit rate: Up to 4 Mbps (DivX)
(Rear) USB 2.0 (Use for Wireless LAN
Adaptor only)
Ethernet: 10BASE-T/100BASE-TX 1 system
SD card slot: Connector: 1 system
Digital Audio Input
Optical: k 1
ARC: k 1
Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
Audio Format: PCM, Dolby Digital
VIDEO SECTION
Signal system: PAL/NTSC
Video output
Output level: 1.0 Vp-p (75 ≠)
Output connector: Pin jack (1 system)
HDMI AV output
Output format: 1080p/1080i/720p/480p
Output connector: Type A (19 pin)
HDMI (with 3D, ARC, Content
Type)
This unit supports “HDAVI
Control 5” function.
LASER Specification
Class 1 LASER Product
Wave length: 780 nm (CDs)/660 nm (DVDs)/
405 nm (BDs)
Laser power: No hazardous radiation is
emitted with the safety
protection
WIRELESS SECTION
Wireless module
Frequency range: 2.4 GHz to 2.4835 GHz
No. of channels: 3
SCBFT800_VQT2Z56_eng.book 50 ページ ２０１０年８月４日 水曜日 午後５時１０分
To Next Page
Loading...
