Panasonic SC-HC395EG

12
6 Service Mode
This unit is equipped with features of self diagnostic & doctor mode setting for checking the functions & reliability.
6.1. Self Diagnostic Table
Self Diagnostic Mode To enter into self diagnostic
checking
Item
FL display Key operation
Mode name Description
Error code information
Delete Error code
Example:
System will perform a check on
any unusual/error code from the
memory
To clear the stored in memory
(EEPROM IC)
Opecon version
Cold Start
To display model name & version
Model Name
HC295
HC297 DAB
HC395
HC397 DAB
HC195
Version display
_6AA㻜***_
_6AB㻜***_
_6AC㻜***_
_6AD㻜***_
_6AE㻜***_
Step 1 : Select CD mode
(Ensure no disc is inserted).
Step 2 : Press [ ] button on mainset
for more than 2 sec and
press [ ] on mainset
for more than 2 sec.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
Step 1 : In self diagnostic mode,
Press [STOP] on main unit.
It can display up to 5 latest
error code
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
Step 1 : While displaying the error
code, press and hold [OK]
on remote control for more
than 5 second.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
In self diagnostic mode,
Opecon version display and
firmware version display will be
shown one at a time each time
[DISPLAY] key press. When press
[DISPLAY] key during the last
firmware version display (refer to left
table), the first version display
(opecon version) should display
again.
In version display mode, when press
STOP key should go to error code
display mode.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
In self diagnostic mode,
Press [SETUP] button on the remote
control.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
To activate cold start upon next
power up.
(Backup data are initialized)
ROM
type
Version
display