50
9.3. Checking of CD Interface P.C.B.
Note : Insert CD before Checking CD Interface P.C.B.
Step 1 : Remove Front Ornament Unit (L) & (R).
Step 2 : Remove Front Panel Block.
Step 3 : Remove CD Mechanism.
Step 4 : Remove screw.
Step 5 : Release 5P wire from the slots.
Step 6 : Release catches.
Step 7 : Remove Bridge P.C.B..
Step 8 : Place a Support Block to support Front Panel Block as
shown.
Step 9 : Connect 14P FFC at connector (CN941) on Bridge
P.C.B..
Step 10 : Place CD Mechanism on Insulating Material.
Step 11 : Connect 24P extension cable (REE1978) from P5003
on Main P.C.B. to CN7002 on CD Interface P.C.B..
To Next Page
Loading...
