51
Step 12 : Check CD Interface P.C.B. according to the diagram
shown.
9.4. Checking of Main P.C.B.
Step 1 : Remove Front Ornament Unit (L) & (R).
Step 2 : Remove Front Panel Block.
Step 3 : Remove NFC P.C.B..
Step 4 : Remove SMPS Unit.
Step 5 : Remove Bottom Ornament Unit.
Step 6 : Remove CD Mechanism.
Step 7 : Remove DAB Unit. (HC397)
Step 8 : Remove Main P.C.B..
Step 9 : Place Main P.C.B. on the Insulating Material.
Step 10 : Connect 2P wire at connector (CN400) on Main
P. C .B ..
Step 11 : Connect 2P wire at connector (CN401) on Main
P. C .B ..
To Next Page
Loading...
