38
8.24. Disassembly of CD Interface
P.C.B.
• Refer to “Disassembly of CD Mechanism”
Step 1 : Release catches and push down fixed pins as arrow
shown.
Step 2 : Lift up Mecha Chassis & remove Floating Springs.
Caution : Keep the Floating Springs and place them back
during assembling.
Step 3 : Remove 2 screws.
Step 4 : Desolder points on CD Interface P.C.B..
Step 5 : Lift up the Connector Cover.
Caution : Do not use strong force as it may damage the
connector cover.
Step 6 : Detach 24P FFC at connector (CN7003) on CD Inter-
face P.C.B..
To Next Page
Loading...
