Before use
4
RQT7357
A The remote control
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Do not use rechargeable type batteries.
Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to flame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which
can damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
■ Use
Aim at the remote control sensor, avoiding obstacles, at a
maximum range of 7 m (23 feet) directly in front of the unit.
Refer to page 6 for the remote control sensor position.
B Placement of speakers
Speakers are designed identically so that no left or right channel
orientation is necessary.
Notes
• Keep your speakers at least 10 mm (
13
/32˝) away from the
system for proper ventilation.
• These speakers do not have magnetic shielding. Do not place
them near televisions, personal computers or other devices
easily influenced by magnetism.
• To avoid damage to the speakers, do not touch the speaker
cones if you have taken the nets off.
C Connections
Plug the AC power supply cord into a household AC outlet only
after all other connections have been made.
• To prepare the AM loop antenna wire and speaker cords, twist
the vinyl cover tip and pull off.
1 Connect the FM indoor antenna.
Tape the antenna to a wall or column, in a position where
radio signals are received with the least amount of interfer-
ence.
Note
For the best reception:
An FM outdoor antenna is recommended. (\ page 5)
A
R6, AA, UM-3
B
C
3
4
1
2
(R)
(L)
1
AM ANT
EXT
FM ANT
75
LOOP
(Continued on next page)
To household
AC outlet
Adhesive
tape
FM indoor
antenna
RQT7357-C_04-07_EN 12/1/04, 5:59 pm4
To Next Page
Loading...
Need help?
General
