RQT8927
13
∫ Attaching to a wall
You can attach the front/center speakers to a wall.
≥The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg per screw.
Consult a qualified building contractor when attaching the speakers to a wall. Improper attachment may result
in damage to the wall and speakers.
1 Drive a screw (not included) into the wall. 2 Fit the speaker securely onto the screw(s) by
matching them with the hole(s).
∫ Fitting speaker stands (not included)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance between screws as shown in the diagram.
≥The stands must be able to support over 10 kg.
≥The stands must be stable even if the speakers are in a high position.
§This is one example of configuring speaker stands.
Preparation
Attach screw eyes (not included) to secure the speakers
to a wall.
1 Thread the string (not included) through the slot
on the rear of the front/center speakers to
prevent them from falling over.
2 Loop the string through the screw eye and tie
tightly.
≥You will need to obtain the appropriate screw eyes to
match the walls and pillars to which the screw eyes
are going to be fastened.
≥Consult with a qualified housing contractor concerning
the appropriate procedure when attaching to a
concrete wall or a surface that may not have strong
enough support. Improper attachment may result in
damage to the wall or speakers.
Speaker installation options
‰7.5 to 9.4 mm
4.0 to 6.0 mm
Wall or pillar
‰4.0 mm
Front/center speaker
24.5 mm
Speaker stand
§
(not included)
Plate thickness
plus 7 mm to
10 mm
Front/center speaker
5 mm, pitch
0.8 mm
Metal screw
holes
For attaching to
speaker stands
60 mm
55 mm
Preventing the speakers from falling over
Screw eye (not included)
String (not included)
Approx. 150 mm
Wall
Getting Started
UICK S
T GUID
QUICK START GUIDE STEP 1
PTX7EB.book Page 13 Monday, March 12, 2007 10:13 AM
To Next Page
Loading...
