30
Step 13 Install the gear holder, and then tighten the screw
(a).
Step 14 Install the tray base, traverse ass’y, mechanism
cover and upper plate.
[Operation check after servicing]
Check the proper operation of following items with gear
and hexagonal screwdriver.
1. Open/close of tray base.
2. Moving the tray base to the stock side.
3. UP/DOWN operation of spindle base unit.
4. UP/DOWN operation of traverse ass’y.
10.12.4 Replacement for the motor ass’y
Step 1 Install the belt temporarily.
NOTE:
Take care not apply the grease to the belt.
Step 2 Upset the CD loading unit.
Step 3 Remove 3 screws
Step 4 Unsolder the plunger terminals (2 points).
Step 5 Unsolder the motor terminals (2 points).
To Next Page
Loading...
