Panasonic SC-TM23 - Replacement for the Pinch Roller Assy and Head Block

Step 6 Release the 2 claws (A), and then remove the Motor
P.C.B.
Step 7 Release the claw (B), and then remove the motor
ass’y.
[Notice for motor ass’y installation]
1. Locate the name plate of motor to the traverse
ass’y.
2. Align the hole of motor with the ribs.
31
10.13 Replacement for the pinch roller ass’y
and head block
· Follow the (Step 1) - (Step 2) of Item 10.2 -
Disassembly of Top Cabinet
· Follow the (Step 1) - (Step 6) of Item 10.3 -
Disassembly of CD Lid
· Follow the (Step 1) of Item 10.4 - Disassembly of the
Rear Panel
· Follow the (Step 1) - (Step 3) of Item 10.5 -
Disassembly of the CD Mechanism Unit
· Follow the (Step 1) - (Step 3) of Item 10.9 -
Disassembly of the Front Panel Unit
· Follow the (Step 1) - (Step 5) of Item 10.10 -
Disassembly of the Deck Mechanism Unit
* The mechanism as shown below is for DECK1. For DECK 2,
perform the same procedures.
Step 1 Release the 2 claws, and then remove the pinch
roller (R), (F).
Step 2 Release ther 2 claws, and then remove the head
connector