Panasonic SC-TM23

81
Pin No. Mark I/O Function
59 REC /O L when record circuit is
operating
60 DECK1_H O H when DECK 1 P/B head
is selected
61 N.C. - No Connection
62 Vcc - Power Supply (+5V)
63 N.C. - No Connection
64 Vss - Ground (0V)
65-66 N.C. - No Connection
67 V_JOG_A I Volume Jog A
68 V_JOG_B I Volume Jog B
69 EX1_CLK I/O *1 I/O Expander Clock
70 EX1_DAT I *1 I/O Expander Data
71 /FL_RESET O Reset Input (ACTIVE L)
72 FL_CS I/O FL Driver Chip Select
73 FL_DOUT O Serial Data To FL Driver
(Output)
74 FL_CLK I/O Serial Clock To FL Driver
75 N.C. - No Connection
76 SSEQ_LED O Super Sound EQ LED
77 CD_RST O CD Reset Output
78 STATUS I CD Servo LSI Status Input
79 MLD O CD Command Load
Output
80 MDATA_OUT O CD Command Data
Output
81 MCLK O CD Command Clock
Output
82 /RESTSW I CD Limit Switch Input for
the Most Inner Point
(Active Low)
83 CHG_HLF O Changer Half Drive
Output
84 CHG_CW O Changer Motor Clockwise
Output
85 CHG_CCW O Changer Motor
Counterclockwise Output
86 CHG_SW1 I CD Changer Switch 1
Input
87 CHG_SW2 I CD Changer Switch 2
Input
88 CHG_PLR O Changer Plunger Output
89 CHG_AD2 I Changer AD Detection
Input (Position/Bottom)
90 CHG_AD1 I Changer AD Detection
Input (Open/Clamp)
91 DECK2 I DECK CONDITION
INPUT 2(R_INHF/
MODE2/HALF2)
92 KEY3 I KEY3 INPUT
93 KEY2 I KEY2 INPUT
94 KEY1 I KEY1 INPUT
95 PHOTO_2 I Rotation Detection Signal
(Deck 2)
96 AVss - Analog Power Supply
Input (Connect to GND)
97 PHOTO_1 I Rotation Detection Signal
(Deck 1)
98 VREF - Reference for A-D (5V)
99 AVcc - Analog Power Supply
Input
100 Demo Selector I (H= default demo on, L=
default demo off.)