Panasonic TH-50PF11UK - Removal of DN-Board; Removal of D-Board; Removal of P-Board; Removal of Speaker Terminal Block (L, R)

22
TH-50PF11UK
8.8. Removal of DN-Board
1. Disconnect the connectors (DN3, DN5, DN9, PB31,
PB32, PB33, PB34, PB35, PB38).
2. Remove the flexible cables from the connectors (DN1,
DN2).
3. Remove 4 screws and then remove the DN-Board Block.
4. Remove 2 screws ( ) and then remove the PB-Board
Block.
5. Remove 2 screws ( ) and then remove DN-Board.
Note:
A re-setup of the destination is performed by MS
mode after DN-Board exchange.
8.9. Removal of D-Board
1. Remove the Slot Block.
(Refer to Removal of Slot Block)
2. Disconnect the connectors (D3, D5, D25).
3. Remove the flexible cables from the connectors (D20,
D31, D32, D33).
4. Remove 4 screws and then remove D-Board.
8.10. Removal of P-Board
1. Disconnect the connectors (P2, P6, P7 P9, P11, P12,
P25).
2. Remove 6 screws ( ) and then remove P-Board (MAIN)
and Fixed Plate.
3. Remove 6 screws ( ) and then remove P-Board (AC).
8.11. Removal of Speaker Terminal
Block (L, R)
1. Remove each 1 screw and then remove the Speaker Ter-
minal Block (H3 Circuit Board) (L, R).
2. Turn over the Speaker Terminal Block (L, R) and then dis-
connect the connector (H37).