31. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a t with the plasma panel
surface facing downward.
32. Remove the stand blocks (left, right) fastening screws (x4
each) and remove the stand blocks (left, right).
33. Remove the Flexible Cable from the connectors (C10,
C11).
34. Remove the Flexible Cable from the connector (C20).
35. Remove the connectors (C21 and C22).
36. Disconnect the connectors (C32, C33, C35).
37. Disconnect the connector (SS34).
38. Remove 2 screws(G) and then remove the S1-Board Block.
39. Disconnect the connector (S34).
40. Remove 1 screw(H) and then remove the S1-Board.
41. Remove the Flexible Cable from the connectors (C20, C21,
C22).
42. Disconnect the Fan Relay Couplers.
43. Remove each 3 screws and then remove 2 Fan Blocks.
17
TH-50PH10BK / TH-50PH10BS / TH-50PH10EK / TH-50PH10ES
To Next Page
Loading...
