Panasonic TH-55LFV8W - Page 16

Set the remote control ID when you want to use this
remote control on several different Displays.
Press the [ID] button. The red LED will blink twice.
1. Press the [ID SET] button for more than one second
to enter the ID Mode. The red LED will come on.
Pressing the [ID SET] button again will exit the ID
Mode.TheredLEDwillgoo󰀨.
Press digits [0] ~ [9] to select the Display you want
to control.
For example: press [0] and [1] for Display No. 1,
press [1] and [1] for Display No. 11.
The numbers available are from [01] ~ [255].
2. The ID Mode will terminate if no selection is made
within 10 seconds.
3. If a button other than a digit is pressed by mistake,
waitforonesecondaftertheredLEDgoeso󰀨and
comes on again. Now choose the correct digits.
4. Press[IDENTER]toconrm.TheredLEDwillblink
twiceandthengoo󰀨.
Notes
●
Press the [NORMAL] button. The green LED blinks
twice, to indicate the Display is in normal operation
mode.
●
It is necessary to set up the Monitor ID for each
Display before selecting its ID number.
English
16