Command
Command Parameter Control details
PON None Power ON
POF None Power OFF
AVL *** Volume 000 - 060
AMT
0
Audio MUTE OFF
1 Audio MUTE ON
IMS
None Input select (toggle)
HM1
HDMI1 input (HDMI1)
HM2 HDMI2 input (HDMI2)
DP1
Display Port IN input (Display
Port)
DV1 DVI-D IN input (DVI-D)
PC1
PC IN input (PC)
VD1 VIDEO input (VIDEO)
YP1
COMPONENT input
(COMPONENT)
UD1 USB input (USB)
MDC
0 Tiling Enable Off
1 Tiling Enable On
Attention
●
Intervals between multiple commands should be at
least 750 ms.
●
When sending multiple commands, be sure to
receive a response from this unit before sending
the next command. When sending a command
that does not require a parameter, no colon (:) is
necessary.
●
When using the serial control, set “Eco mode” to
“Normal”. ( See page 31)
●
When using Video Wall Manager, set “Eco mode” to
“Normal”. ( See page 31)
Notes
●
If a wrong command has been sent, the command
”ER401” will be returned to the PC.
●
In the standby state (power turned off by remote
control or the Display power button)
When ”Eco mode” is set to ”normal”operations other
than the ”PON” command cannot be guaranteed.
When ”Eco mode” is set to
”low power standby”operations other than the
”PON” command cannot be guaranteed. Also, the
”PON” command does not respond.
●
Only commands to monitors with corresponding IDs
will be accepted.
The formats are shown below.
(Type1) AD94;RAD:<XXX>;
(Type2) RAD:<XXX>;
<XXX> represents monitor ID 001 to monitor ID
100, or 000.
000 is the simultaneous transmission command (ID
all command) to all the monitors.
●
When using the monitors in a serial daisy chain, set
the Monitor ID to avoid overlapping in all displays,
and use commands with ID.
●
For command details, consult the dealer from which
the product was purchased.
Or, visit the support site shown below.
https://panasonic.net/cns/prodisplays/
●
Video Wall Manager
This unit supports the “Video Wall Manager”
software which adjusts multiple displays
simultaneously or separately on one computer
without the need to rearrange cables.
●
For more details, visit the following web site.
https://panasonic.net/cns/prodisplays/download/
software/index.html
IR terminal connection
It is possible to receive signals from the remote control
by connecting the supplied external IR receiver to the IR
IN terminal.
Notes
●
An external IR receiver is supplied with this unit.
●
If the external IR receiver or the IR cable is connected
to the IR IN terminal of the Display, control is limited
to this Display.
IR IN IR OUT IR IN IR OUT IR IN IR OUT
1
5
外部IR受信機
External IR receiver (supplied)
First display
Second display
Third display
IR Daisy Chain Cable (supplied)
USB terminal connection
Connect a USB device to use [USB media player].
1
USB
USB memory device
Pin assignments and signal names for USB Terminal
External IR
Receiver
English
24
To Next Page
Loading...
