• {Lock power}: Disable all keyboard functions except
the
[POWER]
button.
• {Lock all except volume and power}: Disable all
keyboard functions except the
[ ], [ ]
and
[POWER]
buttons:
RC lock
Choose to enable or disable the button function of the
remote control.
• {Unlock}: Enable keyboard functions.
• {Lock all}: Lock all keyboard functions.
• {Lock volume}: Disable all keyboard functions
except the
[ ]
and
[ ]
buttons.
• {Lock power}: Disable all keyboard functions except
the
[POWER]
button.
• {Lock all except volume and power}: Disable all
keyboard functions except the
[ ] [ ]
and
[POWER]
buttons:
Note
●
To disable the lock function from
Local KB lock or -RC lock press [MENU]
and 1 9 9 8 on the remote control.
Pixel shift
With a video input source you can choose {On} to move
the screen image automatically to protect the Display
from “burn-in” or “after-image” effects after every 30
seconds of static display.
Smart power
Choose a backlight level to optimize dynamic power
consumption and picture contrast.
The options are: {Off}, {Standard}, {Best Power},
{Best Picture}.
Wake on Lan
Choose {On} to turn on the Display through the network.
Switch on state
Choose the Display status to be used the next time the
power cord is connected.
• {On} - The Display will turn on when the power cord
is connected to a power outlet.
• {Standby} - The Display will remain in standby when
the power cord is connected to a power outlet.
• {Last status} - The Display will return to the previous
powerstatus(on/o/standby)whenthepowercord
is removed or replaced.
LED
Choose {Off} to turn off the indicator.
Switch on delay
Adjust the power-on delay time (in seconds) to allow
sequential power-on for each Display when multiple
Displays are connected.
APM
Choose {On}. Then the Display will automatically turn off
when there is no signal.
Information OSD
The information OSD will be displayed in the upper left
corner of the screen when [POWER] is pressed to turn
the Display on from standby, or to change the input
signal.
Choose {Off} to turn this function off.
Display Port Ver.:
Set the DisplayPort version to 1.1a or 1.2, this setting is
only valid on DisplayPort input and output,
1.1a: Switch DisplayPort Ver. to 1.1a(default),
DisplayPort output is a clone of DisplayPort input.
1.2: Switch DisplayPort Ver. to 1.2 to support MST
(Multi-Stream Transport)
Note
●
If the Display screen is black or abnormal under
DisplayPort source, please switch to 1.1a and turn the
AC power off and on again.
Cooling Fan
Select {On} to keep the cooling fan running all the time.
Select {Auto} to allow the cooling fan to go on or off
depending on the Display temperature.
Select {Off} to keep the cooling fan off all the time.
Note
●
The default {Auto} option will start the cooling fan
running should a temperature of 60°C (140°F) be
reached.
SERIAL response (ID all)
When ”On” is selected, the response will be, receiving
ID all (ID:000) using the serial command. ( See page
23-24)
Notes
●
ID:000 is the simultaneous transmission command
(ID all command) to all the Displays.
●
When using the Monitors in serial daisy chain, use
commands with ID. When using the ID all command
(ID:000), set only the last Display to ”On”.
Factory settings
Reset all your customized settings to the factory default.
Note
●
Menu language,Monitor ID and Eco mode setting
values are not reset.
33
English
To Next Page
Loading...
