36
Set Touch Pen mode.
Select “Touch-Pen Mode” in “Setup” menu and press
button.
“SLOT INPUT” is displayed when an optional Terminal Board is installed.
When a Terminal Board with dual input terminals is installed, “SLOT INPUT A”
and “SLOT INPUT B” are displayed.
Touch-Pen Mode
Off
SLOT INPUT
HDMI
Off
Off
Off
NETWORK
DVI
PC
Off
Touch-Pen Mode
Set “On” or “Off” for each input terminal.
If you switch to the input terminal that is set to “On”, the mode becomes Touch Pen
mode.
“Touch-Pen: On” is displayed in Touch Pen mode.
Notes:
• When the following signal input, “Touch-Pen Mode” are disabled:
50i/50p/25p/24sF/24p signals and PC format signals with 50 Hz vertical frequency.
• The electronic pen cannot be used when VIDEO or COMPONENT input is selected.
• When using the electronic pen, adjust “Pos./Size” so that the screen of the computer can be correctly displayed.
(see page 25)
Setting the Remote Control
You can also turn Touch Pen mode On/Off with the FUNCTION buttons on the remote control. (see page 45)
In Touch Pen mode, the menus and functions are restricted as follows.
Pos./Size menu
1:1 Pixel Mode: On
Over scan: Off
Picture menu Picture Mode: “Normal” or “Dynamic” only. (see page 28)
Setup menu
3D Settings
Signal
Extended life settings
MULTI DISPLAY Setup
Portrait Setup
3D Function: Off
FRAME CREATION: Off
Picture Mode: “Normal” or “Dynamic” only. (see page 28)
MULTI DISPLAY Setup: Off
Portrait Setup: Off
Options menu
Display size: Unavailable
Rotate: Unavailable
ASPECT Controls 16:9
Digital Zoom Unavailable
On
Touch-Pen
To Next Page
Loading...
