67
Speci cations
TH-65PB1E
Power Source 220 - 240 V AC, 50/60 Hz
Power Consumption
Power on 510 W
Stand-by condition 0.5 W
Power off condition 0.3 W
Plasma Display panel Drive method : AC type 65-inch, 16:9 aspect ratio
Screen size 1,434 mm (W) × 806 mm (H) × 1,645 mm (diagonal)
(No.of pixels) 2,073,600 (1,920 (W) ×1,080 (H))
[5,760 × 1,080 dots]
Operating condition
Temperature 0 °C - 40 °C
Humidity 20 % - 80 %
Applicable signals
Colour System NTSC, PAL, PAL60, SECAM, Modi ed NTSC
Scanning format 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 750 (720) / 60p · 50p, 1125 (1080) / 60i · 60p · 50i ·
50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50i
PC signals VGA, SVGA, XGA, SXGA
UXGA ···· (compressed)
Horizontal scanning frequency 15 - 110 kHz
Vertical scanning frequency 48 - 120 Hz
Connection terminals
AV IN VIDEO
AUDIO L-R
BNC
RCA Pin jack × 2
1.0 Vp-p (75 )
0.5 Vrms, Shared with COMPONENT/RGB IN
HDMI TYPE A Connector
COMPONENT/RGB IN
Y/G
P
B/CB/B
P
R/CR/R
AUDIO L-R
BNC
BNC
BNC
RCA Pin jack × 2
with sync 1.0 Vp-p (75 )
0.7 Vp-p (75 )
0.7 Vp-p (75 )
0.5 Vrms, Shared with VIDEO
DVI-D IN
AUDIO
DVI-D 24 Pin
Content Protection
Stereo mini jack (M3) × 1
Compliance with DVI Revision 1.0
Compatible with HDCP 1.1
0.5 Vrms, Shared with PC IN
PC IN
AUDIO
High-Density Mini D-sub 15 Pin
Stereo mini jack (M3) × 1
Y or G with sync 1.0 Vp-p (75 )
Y or G without sync 0.7 Vp-p (75 )
P
B/CB/B: 0.7 Vp-p (75 )
P
R/CR/R: 0.7 Vp-p (75 )
HD/VD: 1.0 - 5.0 Vp-p (high impedance)
0.5 Vrms, Shared with DVI-D IN
SERIAL External Control Terminal
D-sub 9 Pin RS-232C compatible
3D IR TRANSMITTER for 3D IR TRANSMITTER (TY-3D30TRW)
3D SHUTTER OUT
M3 jack × 1
DC 8V OUT Center plus, for EIAJ 4mm plug
WIRELESS MODULE for Wireless module (ET-WM200E)
LAN RJ45 10BASE-T/100BASE-TX, compatible with PJLink™
EXT SP 8 , 20 W [10 W + 10 W] (10 % THD)
Dimensions (W × H × D) 1,554 mm × 925 mm × 99 mm
Mass (weight)
main unit only approx. 60.0 kg net
Notes:
• Design and speci cations are subject to change without notice. Mass and dimensions shown are approximate.
• This equipment complies with the EMC standards listed below.
EN55022, EN55024, EN61000-3-2, EN61000-3-3.
To Next Page
Loading...
