21
TH-85PF12U
8 Service Fixture & Tools
8.1. Service Stand
When conducting repairs and servicing, install the Plasma Display to the Service Stand.
Part number:
TZSA07021
Installation of plasma display:
1. Lock 2 casters.
2. Check that the Alignment bar is set to the Service Stand.
3. Remove 2 screws.
4. Join the stand hooks to the 4 notches on the Service Stand.
5. Tighten 2 screws.
6. Remove the Alignment bar, then start conducting repairs and servicing.
7. After conducting repairs and servicing, remove the plasma display from the Service Stand in reverse order.
Note: Do not over-tighten the screws, as this could cause the fixtures to deform the Service Stand.
To Next Page
Loading...
