Panasonic TX-29FJ50A - Safety Instructions; General Safety Instructions; Connect Aerial Cable to RF In Terminal

Dear Panasonic customer
Welcome to the Panasonic family of customers. We hope that you will have many years of enjoyment from your
new colour television.
Safety Instructions
The TV set can be operated on AC
AUTO 110-240V, 50/60Hz (TX-
29FJ50M) or AC SINGLE 230-
240V, 50Hz (TX-29FJ50A).
The cabinet and picture tube can
be kept in good condition by simply
+ | wiping with a clean, soft cloth
* | moistened with mild detergent and
water. Do not use solutions
containing benzol, petroleum or a
chemical cloth. For safety, remove
the plug from the walt outlet.
Adequate ventilation is essential to
prevent failure of electrical
components.
The apparatus shall not be
exposed to dripping or splashing
and that no objects filled with
liquids, such as vases, shall be
placed on the apparatus.
Do not remove the rear cover, as
live parts are accessible when it is
removed.
Avoid exposing the TV set to direct
sunlight and other source of heat.
Remove the plug from the wall
outlet (Power point) when the TV
set is not used for a prolonged
period of time.
Do not use this set if abnormal
operation occurs.
EX: smoke, odd sounds or smells,
turn the power switch off and
disconnect the AC power if you
notice any unusual operation.
<>
aie ie?
Before Operating This Set
@ Connect the Aerial Cabfe to the RF In Terminal
To obtain the best quality picture and sound, an external VHF Aerial UHF
antenna, the correct cables (75 Ohm coaxial) and the
correct terminating plug will be required.
\f a communal antenna system is used, you may require
the correct connection cable and plugs between the wall
antenna socket and your television receiver.
Your local Television Service Dealer may be able to
assist you in obtaining the correct antenna system for
your particular area and accessories required. 75Q
Any matters about antenna installation, upgrading of Coaxial
existing systems or accessories required, and the cost Cable
incurred, are the responsibility of the customer.
Mixer
RF
in
Terminal
__
Coaxial
Aerial
plug
Hi Battery Installation
Two “R6 (AA)" size
©
6
Open the cover. Insert the two batteries. Close the cover.
Do not use rechargeable (Ni-Cd) batteries. :
Cautions They are different in shape and performance and may fail to ensure correct operation.
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote
Control or cause the batteries to burst.