Auto Setup
Quick Start Guide
13
Auto Setup
Search and store TV channels automatically.
●
These steps are not necessary if the setup has been completed by your local dealer.
●
Please complete connections (p. 11, 12) and settings (if necessary) of the connected equipment before starting Auto
Setup. For details of settings for the connected equipment, read the manual of the equipment.
1
Plug the TV into mains socket and switch on
●
Takes a few seconds to be displayed.
●
If the red LED shows on the TV, press the Standby On / Off switch on the
remote control for about 1 second.
2
Select your country
Country Selection
United Kingdom Ireland
select
set
Example:
Example:
Searching
CH
62
62
62
62
29
33
Channel Name
CBBC Channel
BBC Radio Wales
E4
Cartoon Nwk
BBC1
Type
Free TV
Free TV
Free TV
Free TV
Analogue
Analogue
Quality
10
10
10
10
-
-
Free TV: 8
Pay TV: 0 Radio: 0 Data: 0 Analogue: 2
Auto Setup - DVB and Analogue
DVB Scan
This will take about 6 minutes.
Analogue Scan
CH 21
CH 21
68
68
Searching
CH
62
62
62
62
CH29
CH33
Channel Name
CBBC Channel
BBC Radio Wales
E4
Cartoon Nwk
BBC1
Type
Free TV
Free TV
Free TV
Free TV
Analogue
Analogue
Quality
10
10
10
10
-
-
Free TV: 8
Pay TV: 0 Radio: 0 Analogue: 2
Auto Setup - DVB and Analogue
DVB Scan
This will take about 6 minutes.
Analogue Scan
CH 1
CH 5
41
69
99 H: 21
Auto Setup will start to search for TV channels and store them.
●
Actual number of channels may differ due to channel duplication.
Sending Preset Data
Please wait!
0%
100%
Remote control unavailable
If Q-Link or similar technology (p. 61) compatible recorder with analogue tuner is
connected, analogue channel setting is automatically downloaded to the recorder.
(Digital channel setting is not downloaded.)
●
If downloading has failed, you can download later through the Setup Menu.
“Q-Link Download” (p. 32)
3
Input Owner ID
* * * *
Please enter new PIN
PIN
Owner ID
Please enter your own choice of PIN
number, name, etc. to help the police to
crack crime.
●
Make a note of the PIN number in case you forget it. The PIN number cannot be
reset.
●
You can input or change the Owner ID later. “Owner ID” (p. 48)
●
To skip this step
●
This step will be skipped in the Auto Setup after [Shipping Condition] (p. 47) is
performed.
To Next Page
Loading...
