Setup for Internet Connection
45
Setup for Internet Connection
The ETHERNET terminal is for TV’s software update. You can download a newer version of software through the
internet, if it is available. (p. 46)
●
To update the TV’s software without internet connection “Updating the TV Software” (p. 50)
Network connections
Connect the TV and the Broadband network equipment (modem, hub or router) by using a LAN cable.
Internet environment
∗
Less than 10 cm
LAN cable (Unshielded)
●
Use the Unshielded Twist Pair (UTP) LAN cable.
Ferrite core - Large size (supplied)
Installing the Ferrite core
Pull back the tabs (in two places) Wind the cable twice Close
Note
●
If you do not have any broadband network services, please consult your retailer for assistance.
●
Ensure to use a LAN straight cable for this connection.
●
Set up and connect any equipment required for the network environment. You cannot make settings for the
equipment on this TV. Read the manual of the equipment.
●
Contact your Internet Service Provider (ISP) or telecommunications company for further assistance regarding the
network equipment.
●
Confirm the terms and conditions of the contracts with your Internet Service Provider (ISP) or telecommunications
company. Depending on the contracts, additional fees may be charged or multiple connections to the internet may be
impossible.
[Network Setup]
Ensure the connections are completed before starting Network Setup.
1
Display the menu and select [Setup]
Main Menu
Picture
Sound
Setup
select
access
2
Select [Network Setup]
Setup Menu
Network Setup Access
access
select
Note
[MAC Address]
●
MAC address is a unique address that identifies hardware in the network. (for information only)
Network Setup
MAC Address ab-cd-ef-gh-ij-kl
IP/DNS Settings
Connection Test
Software Update
To Next Page
Loading...
