Panasonic VL-V591 - Programming Functions; How to Program Settings

12
Programming
1 To enter programming mode, press and hold the PROGRAM switch for about 2 seconds
during standby.
2 Enter the desired function code, then press {CALL}.
Function Code
Registering room numbers
001
Conrming a room number
002
Conrming all room numbers
003
Canceling the registration of a room number
004
Canceling the registration of all room numbers
044
Setting the PIN
005
Setting the time for how long the door remains open using the PIN
006
3 Perform the operation according to the function. To save the setting, press {CALL}.
LTo end the setting, press {CLR}.
4 To end programming mode, enter {9}{9}{9}, then press {CALL}.
LThe unit returns to standby.
Note:
LThe DOOR OPEN indicator/BUSY indicator function as follows while programming.
Setting status DOOR OPEN indicator BUSY indicator
The unit is in programming mode. OFF Flashes rapidly
The function code is entered. You can set the function. OFF Flashes slowly
The unit is waiting to save the setting. Flashes slowly Flashes slowly
The setting is being saved. Lights (for 1 second) Flashes slowly
Error (such as when an invalid number is entered.) ------ Lights
LWhile programming the function in steps 2 to 3, you can stop programming by pressing {CLR}.
How to program the settings
To register room numbers or program other settings, you need to enter programming mode using the PROGRAM switch on
the rear of the upper cabinet (page 5). To press the PROGRAM switch, use a pointed object such as a pen.
BUSY indicator
DOOR OPEN indicator
{CLR}
{CALL}
VL-V591_IG_en.indd 12 2017/09/22 19:03:00