Panasonic VL-V591 - Important Information; For Your Safety; Installation Precautions; Operating Safeguards

3
Important Information
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the unit to ensure proper
and safe operation of your unit.
WARNING
Power connection
LUse only the power source marked on the unit. If you are not sure of the type of power supplied to the building,
consult your dealer or local power company.
LUse only the specied power supply unit.
LDo not place objects on the power cable. Install the unit where no one can step or trip on the cable.
LDo not overload power outlets and extension cords. This can result in the risk of re or electric shock.
LCompletely insert the power plug into the power outlet. Failure to do so may cause electric shock and/or
excessive heat resulting in a re.
LRegularly remove any dust, etc. from the power plug by pulling it from the power outlet, then wiping with a dry
cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a re.
LUnplug this unit from power outlets if it emits smoke, an abnormal smell or makes unusual noise. These
conditions can cause re or electric shock. Conrm that smoke has stopped and contact an authorized service
center.
LNever touch the plug with wet hands. Danger of electric shock exists.
LDo not connect a power cable to a terminal that is not specied in this guide. Connecting to the wrong terminal
may cause electric shock and/or excessive heat resulting in a re.
Installation
LLeave installation work to the dealer.
Installation work requires technique and experiences. Failure to observe this may cause re, electric
shock, injury, or damage to the product. Consult the dealer.
LElectrical connection work should be performed by certied personnel only.
Certication is required for performing electrical connection work. Consult your dealer.
LDo not install the product in a place where there is high humidity.
LDo not install the power supply unit in the following places:
– Places where the power supply unit may be splashed with water or chemicals.
– Places where there is a high concentration of dust, or high humidity.
LDo not allow the power cable or power plug to be excessively pulled, bent or placed under heavy objects.
LDo not make any wiring connections when the power supply is turned on.
LNever install wiring during a lightning storm.
LWhen existing wires are used, it is possible that they contain AC voltage. Electric shock or unit damage could
result. Contact an authorized service center.
Operating safeguards
LTo reduce the risk of electric shock, do not disassemble this unit. Refer servicing to an authorized service
center when service is required. Opening or removing covers may expose you to dangerous voltages or other
risks. Incorrect reassembly can cause electric shock when the unit is subsequently used.
LDo not touch the power supply unit/power plug during an electrical storm. There may be a remote risk of
electric shock from lightning.
LNever push any objects through slots in the power supply unit. This may result in the risk of re or electric
shock. Never spill any liquid on the power supply unit.
LUnplug this unit from power outlets and refer servicing to an authorized service center when the following
conditions occur:
A. If the power cable is damaged or frayed.
B. If metal objects have been dropped inside the unit.
C. If the power supply unit has been exposed to rain or water, or liquid has been spilled into the power supply
unit.
D. If the unit has been dropped or physically damaged.
VL-V591_IG_en.indd 3 2017/09/22 19:02:55