Panasonic VL-V591 - Controls Overview; Location of Controls

5
Controls
Location of controls
Main unit
A Camera
B Lens cover
C BUSY indicator
LLights when the called main monitor station is in use.
D DOOR OPEN indicator
LLights when the door of the common entrance is
opened.
E Keypad
F {CLR} (CLEAR) button
LTo stop the operation.
G Speaker
H Microphone
I Room number display
J {CALL} button
LWhen a visitor presses the call button after entering the
room number, a ringer tone will ring.
K Room number plate
LYou can write down room numbers on this plate by
removing the rear cover from the upper cabinet.
L Rear cover (for the room number plate)
M Camera angle control lever (page 8)
N PROGRAM switch
LTo register room numbers and program other settings
(page 12-14).
Use a pointed object such as a pen to press this switch.
O RESET switch
LTo reset the unit if it is not working properly.
(The program settings are not affected.)
Use a pointed object such as a pen to press this switch.
P BACKLIGHT COMPENSATION switch (page 9)
Q Speaker volume switch (page 9)
R Water drain holes
LThese holes allow rain water to drain.
Do not cover them.
N Upper cabinet rear view
LThe gure below shows the appearance when
the lower cabinet is removed (page 8).
N Upper cabinet front view
B
C
D
E
F
G
H
I
J
K
M
O
P
N
Q
R
L
A
N Lobby station image quality
The following phenomena may occur. They are not malfunctions.
L If the sun can be seen, its center appears as a black dot.
LAt night or when there is poor lighting in the doorway, the image colors become unclear. If there is a light in the
doorway, the image may appear greenish.
LDuring the daytime or if there is bright light in the doorway, the color of the visitor’s clothing may appear differently to
the actual color.
VL-V591_IG_en.indd 5 2017/09/22 19:02:55