Panasonic VL-V591 - Main Unit Installation; Installing the Main Unit; Adjusting the Camera Angle

8
Installation
Installing the main unit
After installing the power supply unit and the ush mounted box (page 7), install the main unit.
Important:
LOn the bottom surface of the upper cabinet, there are holes to allow water to drain. Do not cover them up when installing.
1 Remove the 2 screws attached
to the bottom of the upper
cabinet.
2 Slide the upper cabinet
upwards, then remove the
lower cabinet.
1
A
B
D
G
H
DC cable
connected to the
power supply unit
<Upper cabinet>
<Lower cabinet>
Wires connected
to rooms and the
door opener
G
Water drain
holes
Wall
2
<Flush mounted box>
C
Screw
Screw
Screws
N Adjusting the camera angle
<Upper cabinet rear view>
Upwards
(maximum 15°)
Camera angle
control lever
Downwards
(maximum 5°)
<Examples of camera angles>
Facing forwards Facing upwards Facing downwards
Separate the upper cabinet and lower cabinet.
Screws
Wall
To power outlet
E
DC cable
<Power supply unit>
AC cable
To lobby
station
VL-V591_IG_en.indd 8 2017/09/22 19:02:58